Cinewhoop Splash From Jacks 3D

WIP!

https://www.quadjunkie.co.nz/product/splash-cinewhoops-from-jacks-3d

DJI

Activations and updates

• Air Unit 03 was done with DJI Assistant 2(Consumer Drones Series) 2.1.38 which is software on my PC
• DJI Goggles Integra was done with DJI Fly which is a software on my phone

Connecting the the flight contoller to the air unit was done using the 7 pin connector, the 03 Air Unit only needs 6 of the pins

VCC ~ power
GND ~ ground
TX2 ~ UART RX
RX2 ~ UART TX
GND ~ not needed
RX1 ~ SBUS, yellow wire, not needed as Im using Futaba SBUS